80 Series DIY Power Tray DXF file | WITH Blank Space
This is the DXF file you will need to send to Sendcutsend.com to get it cut, or if you know someone with a plasma table they can cut it for you as well.
I used .100” Thick - 5052 Aluminum Sheet.
The panel will have cutouts to accept a switch assembly & circuit breaker from an Auxbeam 8 Gang RGB kit.
Please note this only works for the Aux Beam 8 Gang RGB switch panel!
The rest of the panel will be a blank slate for you to add anything else you may need.
Blank area approximately 5.5”x4.5”
(There is another panel available with the cutouts for the blue sea bus bar I used in my video if you wish to go that route)
*IMPORTANT* You will need to pick up a piece of aluminum angle iron from your local hardware store to complete this project. You will need to rivet, weld, bolt, or use some other method of attaching the aluminum angle to the panel in the appropriate spot.
Please see the youtube video for more details on installation Video of install